Webasto Air Top 2000 S D Manual de servicio descargar pdf (Pagina 22)

Troubleshooting Air Top 2000 ST

502

5.3 Error symptoms during function

The following table (Fig. 502) lists the possible error

symptoms in the order in which they may occur during

operation.

In the event of a fault, the error is to be located using this

table and rectified. It is important that the error symptom is

correctly identified.

If the error symptom is not included in this table or if the

fault is not found under the specific error symptom heading,

in an emergency you can contact our technicians on our

service hotline.

NOTE

Every fault is indicated by the flashing LED on the control

element after the slow down time has finished. If the other

components are OK, a defective control unit may be the

cause of all the faults.

There are states which are equivalent to faults.

Error symptom Occurrence Possible cause

No start and no illumination of the LED

on the control element

immediate Incorrect cabling, defective fuse

No start but LED is lit immediate The unit immediately goes into a control pause when

switched on; the control pause speed is 0 rpm for a

boat heater.

Fig. 502 Error symptoms during function

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 69 70

Sin comentarios

Webasto Air Top 2000 S D Manual de servicio Pagina 22