Webasto Air Top 2000 S D Manual de servicio descargar pdf (Pagina 10)

Introduction Air Top 2000 ST

104

NOTE

If any damage or leaks are found on the fuel line, the heater

must not be used until the damage has been rectified by an

authorised Webasto workshop.

Put the heater out of action by removing the fuse.

Overheating

Keep the hot air inlet and hot air outlet free of dirt and for-

eign bodies. Dirty, blocked air lines can cause the heater to

shut down due to overheating.

After an overheating lock-out, check that the air system is

clear, remove any materials that may block the air current

and have any damage to the air lines repaired by an author-

ised Webasto workshop. After this the heater lockout can

be cancelled by switching it off and then on again. If this

action does not produce the required success (if the heater

overheats again) take it to a Webasto-authorised workshop.

Never remove the grating over the air inlet of the heater.

The air outlet jets or air vents with adjustable flaps must

always be opened to some extent so that the air current

through the heater is not completely blocked. At least one

air vent must be non-closable.

If the heater is installed in a storage area, you must ensure

that no inflammable substances are kept in this area and

that other material does not restrict the air supply to the

heater.

Air lines must be securely fixed to the heater (using pipe

clips, for example) and all other connection points (for

example vents).

IMPORTANT

The errors described below are to be avoided at all costs:

• Do not stand on the heater and do not place any heavy

items on the heater or throw items at the heater.

• Do not place any items of clothing, textiles or similar

materials over the heater or in front of the hot air inlet

side and the hot air outlet.

• The current of hot air in the heater must not be

restricted or blocked by highly inflammable substances

or materials such as rags, cleaning wool, etc.

• Inflammable or explosive substances and gases must

not be placed near or in contact with the heater, the hot

air line, the current of hot air or the exhaust pipe.

• The heater must not be cleaned with a high pressure

cleaner.

• Do not switch the heater off at the main battery switch

or battery isolation switch since otherwise it is possible

that it may suffer long term damage if it is switched off

frequently using the battery isolation switch and this

can cause damage and negative influences on the

function of the heater.

NOTE

Failure to follow the installation instructions and the notes

contained therein will lead to all liability being refused by

Webasto.

The same applies if repairs are carried out incorrectly or with

the use of parts other than genuine spare parts. This will

result in the invalidation of the type approval for the heater

and therefore of its homologation / EC type licence.

You must read the operating manual before starting the

heater for the first time.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 69 70

Comentarios a estos manuales

Sin comentarios

Webasto Air Top 2000 S D Manual de servicio Pagina 10

Comentarios a estos manuales