Webasto FCF 9 Especificaciones Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Operation / Installation Manual FCF 5000, 9000, 12000, 16000, 24000
Page 26
Continued:
FAULT POSSIBLE REASON CORRECTION
Low air flow
Air flow is blocked
Remove any obstructions in return air stream, Clean return
air filter and grille. Check for crushed or restricted ducting,
ducting must be as straight, smooth and taut as possible.
Coil is iced See below.
Coil is iced
Thermostat set point is too low Raise set point.
Improper air flow Remove any obstructions in return air stream. Clean return
air filter and grille. Check for crushed or restricted ducting,
ducting must be as straight, smooth and taut as possible.
Supply air is short-cycling, Redirect supply air so that is not blowing into the return air
stream. Seal any air leaks on duct.
Seawater temperature is below 40
o
F Shut down system to prevent damage to condenser. Allow
coil to defrost (see below).
Humidity level too high.
Close hatches and doors.
When all else fails. Switch air conditioner to heat until ice melts or use hair
dryer to melt.
Check your specific control troubleshooting section,
System runs
continuously.
Set point temperature is improperly set: too low for
cooling or too high for heating.
Raise or lower set point.
Porthole or hatches open. Close all port holes and hatches,
Seawater temperature too high for cooling or too
low for heating.
Seawater temperature will directly affect the air conditioning
unit's efficiency. This air conditioning unit can effectively
cool your boat in water temperatures up to 90°F and heat (if
reverse cycle option is installed) in water as low as 40
0
F.
Improper air sensor location. Check your specific control troubleshooting section,
Digital display is
not lit.
4-pin display cable plugs are not making contact
(unplugged, dirty, bent, or broken pins).
With POWER OFF at the circuit breaker, remove connector
and inspect. If damaged, replace connector or entire display
cable.
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comentarios a estos manuales

Sin comentarios